Inputs
Fit results (worst case, drawing limits)
Minimum radial gaps. A negative value is an interference; its absolute value is the maximum interference. The shank result assumes the datum reference frames of both parts coincide and takes no credit for the remaining pin play, so it is conservative. Gauge tolerances and wear do not enter the fit results.
Gauge L — checks Part L
Gauge U — checks Part U
Before gauging, screw the four threaded setting pins into Thole 1–4. The part passes when it seats fully on the gauge face with all gauge elements engaged.
To do on the drawings (suit_ parameters)
These parameters do not affect the fit results or gauge sizes, but each drawing must define them.